Automatic Level Control Sensor Replacement

Automatic Level Control Sensor Replacement

Removal Procedure

1. Remove the ELC/TRAILER fuse.

2. Important:
When replacing the height sensor a diagnostic system check must be performed.

Raise and support the vehicle. Refer to Vehicle Lifting.





3. Disconnect the automatic level control sensor electrical connector (1).
4. Remove the automatic level control sensor link from the sensor arm ball stud.





5. Remove the automatic level control sensor bracket bolts (1).
6. Remove the automatic level control sensor from the vehicle.

Installation Procedure





1. Install the automatic level control sensor to the vehicle.

2. Notice:
Refer to Fastener Notice in Service Precautions.

Install the height sensor bracket bolts (1).

Tighten the height sensor bracket bolts to 85 Nm (63 ft. lbs.).

3. Install the automatic level control sensor link onto the sensor arm ball stud.





4. Install the automatic level control height sensor electrical connector (1).
5. Lower the vehicle.
6. Install the ELC/TRAILER fuse.
7. Perform a diagnostic system check. Refer to Diagnostic System Check - Vehicle.