Rear Door Lock Replacement

Rear Door Lock Replacement

Removal Procedure

1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the inside handle rods from the rear door inside handle.




4. Disconnect the clip securing the outside handle rod to the rear door lock.




5. Remove the screws from the rear door lock.




6. Disconnect the electrical connectors from the lock.




7. Remove the lock from the rear door with the inside handle rods attached to the lock through the access hole in the inner panel.




8. Remove the inside handle rods from the lock.

Installation Procedure




1. Install the inside handle rods to the lock.




2. Install the lock in position through the access hole in the rear door inner panel.




3. Connect the electrical connectors to the rear door lock.





Notice: Refer to Fastener Notice.

4. Install the lock screws to the rear door lock.

Tighten the lock screws to 10 N.m (89 lb in).




5. Connect the clip securing the outside handle rod to the rear door lock.
6. Install the handle rods to the inside door handle.
7. Install the water deflector.
8. Install the trim panel.
9. Inspect the door lock system for the proper operation.