Seat Back Replacement - Rear (Split Bench)

Seat Back Replacement - Rear (Split Bench)

Removal Procedure

1. Remove the split bench seat. Refer to Seat Replacement - Rear 50-50 Split .
2. Remove the back trim panel from the rear seat. Refer to Trim Panel Replacement - Rear Seat Back .
3. Remove the outer trim panel from the rear seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket) Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .




4. Remove the lower J-hook retainer and pull back the cushion cover to expose the recliner hinge and the center pivot point.




5. Remove the upper bolts from the seat back recliner hinge.




6. Remove the seat back from the inner pivot point by lifting up the outer end of the seat back. Use a quick upward twist to disengage the pivot stud from the pivot socket.

Installation Procedure





1. Place the rear seat back pivot stud to the rear seat pivot point.
2. Install the seat back to the pivot point. Press the seat back into the socket until fully seated.





Notice: Refer to Fastener Notice .

3. Install the bolts to the seat back recliner hinges.

Tighten the bolts to 40 N.m (30 lb ft).





4. Install the lower J-hook retainer.
5. Install the trim panel to the seat back. Refer to Trim Panel Replacement - Rear Seat Back .
6. Install the outer trim panel to the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement - Rear Seat (Bucket) Seat Cushion Outer Trim Panel Replacement - Rear Seat (Split Bench) .
7. Inspect the seat back for proper operation.
8. Install the split bench seat. Refer to Seat Replacement - Rear 50-50 Split .