Wheel Speed Sensor Jumper Harness Replacement - Front

Wheel Speed Sensor Jumper Harness Replacement - Front

Removal Procedure




1. Disconnect the front wheel speed sensor jumper harness to ABS harness connector (8).
2. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
3. Remove the harness (4) from the splash shield retaining clip (5).
4. Remove the harness (4) from the control arm retaining clips (3).




5. Disconnect the front wheel speed jumper harness connector (2) from the front wheel sensor.
6. Remove the front wheel speed sensor jumper harness (1).

Installation Procedure




1. Connect the front wheel speed sensor jumper harness connector (2) to the wheel speed sensor.




2. Install the harness (4) to control arm retaining clips (3).
3. Install the harness (4) to splash shield retaining clip (5).
4. Lower the vehicle.
5. Connect the front wheel speed sensor jumper harness to ABS harness connector (8).
6. Turn the ignition switch to the RUN position, with the engine OFF.
7. Perform the diagnostic system check. Initial Inspection and Diagnostic Overview