Cooling System Draining and Filling (Static Fill)

Draining and Filling Cooling System (Static Fill)

Draining Procedure

Tools Required

J 26568 Coolant and Battery Tester

Caution: To avoid being burned, do not remove the radiator cap or surge tank cap while the engine is hot. The cooling system will release scalding fluid and steam under pressure if radiator cap or surge tank cap is removed while the engine and radiator are still hot.

Important: Draining the cooling system with the pressure cap installed will syphon the coolant from the overflow tank.

1. Remove the coolant pressure cap.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Place a drain pan under the drain cock.
4. Open the radiator drain cock.
5. Drain the cooling system.
6. If a complete engine block drain is required LA1 engine, remove the engine block drain plugs.
7. If a complete engine block drain is required LY7 engine, remove the starter motor.
8. If a complete engine block drain is required LY7 engine, remove the engine block drain plugs.
9. Inspect the coolant.
10. Follow the appropriate procedure based on the condition of the coolant.

* Normal in appearance-follow the filling procedure.
* Discolored-follow the flush procedure. Refer to Flushing.

Filling Procedure

Notice: Refer to Fastener Notice.

1. Close the radiator drain cock.
2. If the engine block drain plugs were removed from the LA1 or LY7 engine, perform the following:

* Apply pipe sealer to the drain plugs.
* Install the drain plugs.

Tighten the drain plugs to 22 N.m (16 lb ft).

3. If the engine block was drained LY7 engine, install the starter motor.
4. Lower the vehicle.
5. Open the cooling system bleeder screws.

Important: Use a 50/50 mixture of DEX-COOL antifreeze and clean, drinkable water.

6. Slowly fill the cooling system with a 50/50 coolant mixture. Refer to Capacities - Approximate Fluid.
7. Close the cooling system bleeder screws.
8. Install the coolant pressure cap.
9. Start the engine.
10. Run the engine at 2,000-2,500 RPM until the engine reaches normal operating temperature.
11. Allow the engine to idle for 3 minutes.
12. Shut the engine OFF.
13. Allow the engine to cool.
14. Top off the coolant as necessary.
15. Inspect the concentration of the engine coolant, using the J 26568.
16. Rinse away any excess coolant from the engine and the engine compartment.