Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure

Important: Turn the ignition switch to the OFF position before you remove the instrument panel cluster.

1. Remove the instrument panel (I/P) cluster trim plate bezel.




2. Remove the screws from the I/P cluster.
3. Disconnect the electrical connectors from the I/P cluster.
4. Remove the I/P cluster.

Installation Procedure

1. Connect the electrical connectors to the I/P cluster.
2. Install the I/P cluster.






Notice: Refer to Fastener Notice.

3. Install the screws to the I/P cluster.

Tighten the screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim plate bezel.
5. Calibrate the electronic compass. Refer to Electronic Compass Calibration.
6. Refer to Programming and Relearning Programming and Relearning