Tail Lamp: Service and Repair

Tail Lamp Replacement

Removal Procedure




1. Open the liftgate.
2. Remove the screws from the tail lamp.
3. Slide the tail lamp rearward in order to disengage it from the retainers on the rear body panel.




4. Disconnect the electrical connector from the tail lamp wiring harness.




5. Remove the tail lamp and side marker lamp sockets from the tail lamp, depressing the locking tab and turning counterclockwise.

Installation Procedure




1. Install the tail lamp and side marker lamp sockets to the tail lamp, turning clockwise until the locking tab is fully seated.




2. Connect the tail lamp electrical connector to the wiring harness.




3. Position the tail lamp retainer slots to the tabs on the rear body panel.
4. Install the tail lamp to the rear body panel, pressing into place until fully seated.

Notice: Refer to Fastener Notice.

5. Install the tail lamp screws to the tail lamp.

Tighten the tail lamp screws to 2 N.m (18 lb in).

6. Close the liftgate.