Brake Switch (Cruise Control): Service and Repair

Cruise Release Switch Replacement

Removal Procedure

1. Remove the left side instrument panel insulator.




2. Rotate the cruise control release switch counterclockwise until the travel stop has been reached (approximately 60 degrees).




3.
Remove the cruise control release switch from the retainer.
4. Disconnect the cruise control release switch electrical connector.

Installation Procedure

1. Install the cruise control release switch electrical connector.




2.
With the electrical connector index notch at the 10 o'clock position, install the cruise control release switch to the retainer.

Important: Do NOT move or push the brake pedal.

3. Slide the switch into the retainer until the plunger is fully depressed into the barrel.




4. Rotate the cruise control release switch clockwise until the travel stop has been reached (approximately 60 degrees). The electrical connector index notch should now be at the 12 o'clock position.
5. Ensure that the cruise control system operates properly.
6. Install the left side instrument panel insulator.