Wiper Motor Module Replacement

Wiper Motor Module Replacement

Removal Procedure




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the underhood electrical center.
4. Remove the cruise control module.
5. Disconnect the wiper motor cover electrical connector.
6. Remove the wiper system drive module bolts.
7. Remove the wiper system drive module from the engine compartment.

Installation Procedure




1. Position the wiper system drive module to the cowl.
Notice: Refer to Fastener Notice.

2. Install the wiper system drive module bolts.

Tighten the bolts to 9 N.m (80 lb in).

3. Connect the wiper motor cover electrical connector.
4. Install the cruise control module and bracket.
5. Install the underhood electrical center.
6. Install the air inlet grille panel.
7. Install the wiper arms.