B0081
DTC B0081
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B0081 0F
- Passenger Presence System Erratic
DTC B0081 39
- Passenger Presence System Internal Electronic Failure
DTC B0081 3A
- Passenger Presence System Incorrect Component Installed
DTC B0081 71
- Passenger Presence System Invalid Serial Data Received
Circuit/System Description
When the ignition is turned ON, the passenger presence system (PPS) and the inflatable restraint sensing and diagnostic module (SDM) performs tests to diagnose critical malfunctions within itself. When the SDM has completed the power-up mode, the SDM will establish communication with the PPS. The SDM will also request the instrument panel cluster to command both of the PASSENGER AIR BAG ON/OFF indicators ON for 5 seconds. If the SDM detects that the PPS has set a current DTC, the SDM will then disable the instrument panel (I/P) module deployment loop, set DTC B0081, and command the AIR BAG indicator ON.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
All of the following conditions must exist for 5 seconds:
B0081 0F
* The SDM has received a fault present message from the PPS.
* The PPS is in assembly plant mode and the SDM is in production mode.
B0081 39
The SDM has received a fault message from the PPS.
B0081 3A
The SDM has received a message from the PPS indicating a vehicle and PPS mismatch.
B0081 71
The SDM has received invalid or no serial data from the PPS.
Action Taken When the DTC Sets
* The SDM commands the AIR BAG indicator ON.
* The I/P module deployment loop will be disable.
Conditions for Clearing the DTC
* The condition for setting the DTC no longer exists.
* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.
Diagnostic Aids
If either the SDM or PPS were replaced, verify that the correct part numbers were used for the vehicle application.
Circuit/System Testing
Important: When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:
* The PPS module
* The SDM module
* The PPS module harness connector
* The SDM wiring harness connector
Verify that DTC U0170 is not set in the SDM.
• If the DTC is set, diagnose that first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle. Diagnostic Trouble Code Descriptions
1. Verify the correct PPS part number is installed in the vehicle.
• If the wrong PPS was installed, replace with the correct PPS.
2. Replace the PPS module.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests