Operation CHARM: Car repair manuals for everyone.

Supplemental Inflatable Restraints



DTC B1370

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B1370 06
- Device Ignition 1 Circuit Short to Ground or Open

Diagnostic Fault Information






Circuit/System Description

The inflatable restraint sensing and diagnostic module (SDM) monitors the ignition signal from the ignition switch. When the vehicle ignition switch is placed in the RUN or CRANK position, the switch supplies voltage to the SDM ignition input terminal. If an open or short to ground in this SDM ignition circuit is detected, then DTC B1370 will set.

Conditions for Running the DTC

Ignition voltage is between 9-16 volts.

Conditions for Setting the DTC

The SDM detects a short to ground or an open in the ignition voltage circuit for greater than 10 seconds when the ignition switch is in RUN or CRANK.

Action Taken When the DTC Sets

* The SDM commands the AIR BAG indicator ON.
* The SDM determines its power mode only from the serial data power mode messages and discards the ignition input for the remainder of the ignition cycle.

Conditions for Clearing the DTC

* The condition for setting the DTC no longer exists.
* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.

Circuit/System Testing

Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.

* SDM

* SDM wiring harness

1. Ignition OFF, remove the underhood AIRBAG fuse.
2. Ignition ON, connect a test lamp between the B+ side to the fuse and ground. The test lamp should turn ON.

If the test lamp is OFF, refer to DTC B1370 in wiring systems and power management.

3. Ignition OFF, install the underhood AIRBAG fuse.
4. Disconnect the harness connector at the SDM.
5. Connect a test lamp between the ignition 1 voltage circuit terminal 32 and ground.
6. Ignition ON, the test lamp should turn ON.

If the test lamp is OFF, test the ignition 1 circuit for an open or a short to ground.

7. If all circuits test normal, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* SIR/SRS Wiring Repairs