B2509
DTC B2508 or B2509
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B2508 01
- Seat Heater Relay Circuit Shorted to Battery
DTC B2508 02
- Seat Heater Relay Circuit Shorted to Ground
Diagnostic Fault Information
Circuit/System Description
The driver and front passenger heated seat heating elements are controlled by a common high current relay internal to the memory seat module (MSM) and the low side by individual element control circuits. The MSM connects the heated seat heater element supply voltage circuits for both seats to a common reference point. This reference point is biased to approximately 2.0 volts. Before the MSM will allow heated seat operation, it checks to see if this reference voltage is shorted to ground or battery voltage. Once the MSM verifies that it is not closing to a shorted heating element, it allows heated seat operation. After which it continues to monitor for a shorted circuit.
Conditions for Running the DTC
The memory seat module must be powered.
Conditions for Setting the DTC
B2508 02
Before the heated seats are activated, the MSM detects a short to ground on the seat heating element supply voltage circuit or control circuit.
B2508 01
Before the heated seats are activated, the MSM detects a short to battery voltage on the seat heating element supply voltage circuit or control circuit.
Action Taken When the DTC Sets
The heated seat function for both the driver and passenger seats will be disabled.
Conditions for Clearing the DTC
* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.
* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.
Circuit/System Testing
1. Ignition OFF, disconnect the X1 and X4 harness connectors at the MSM.
2. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 6 and ground.
^ If the test lamp illuminates, test the supply voltage circuit and the seat cushion and seat back heating element control circuits for a short to voltage.
3. Test for infinite resistance between the left seat heating element supply voltage circuit terminal 6 and ground.
^ If less than infinite, test the supply voltage circuit and the seat cushion and seat back heating element control circuits for a short to ground.
4. Test for infinite resistance between the right seat heating element supply voltage circuit terminal 14 and ground.
^ If less than infinite, test the supply voltage circuit and the seat cushion and seat back heating element control circuits for a short to ground.
5. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 14 and ground.
^ If the test lamp illuminates, test the supply voltage circuit and the seat cushion and seat back heating element control circuits for a short to voltage.
6. If all circuits test normal, replace the MSM.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests
* Driver Seat Back Cushion Heater and Passenger Seat Back Cushion Heater Replacement
* Driver Seat Cushion Heater and Passenger Seat Cushion Heater Replacement (Driver) Driver Seat Cushion Heater and Passenger Seat Cushion Heater Replacement (Passenger)