B2555
DTC B2555
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC B2555 00
- Passenger Compartment Lamp Control Circuit
Diagnostic Fault Information
Circuit/System Description
The CTSY fuse in the I/P fuse block supplies B+ to the body control module (BCM). When the BCM receives a door open signal and the courtesy defeat switch is not active, the BCM supplies B+ to the courtesy lamps. The courtesy lamps are grounded at G302, G401, and G402.
Conditions for Running the DTC
Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
* DTC B2555 00 will set when the BCM detects a short to voltage in the courtesy lamp control circuit.
* DTC B2555 00 will set when the BCM detects a short to ground in the courtesy lamp control circuit.
Action Taken When the DTC Sets
DTC B2555 00 is present, when a short to ground or short to voltage on the courtesy lamp control circuit is present.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Circuit/System Testing
1. Disconnect the harness connector at the cargo lamp.
2. Connect a test lamp between the courtesy lamp control circuit terminal C and ground.
^ If the test lamp illuminates, locate and repair a short to voltage in the courtesy lamp control circuit.
^ If the test lamp does not illuminate, locate and repair a short to ground in the courtesy lamp control circuit.
3. If all circuits test normal, test or replace the BCM.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests