C0297
DTC C0297
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC C0297 00
- Brake Applied Output Circuit
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) provides a 5-volt reference voltage and a low reference signal to the brake pedal position sensor (BPPS). When the brake pedal is applied, the BPPS sends a variable voltage signal, that will increase as the brake pedal is applied, through the stop lamp switch signal circuit to the BCM. The BCM then applies a signal through the stop lamp switch signal circuit to the engine control module (ECM) and transmission control module (TCM).
Conditions for Running the DTC
* The engine must be ON.
* The brake must be applied.
Conditions for Setting the DTC
The BCM detects a short to ground in the stop lamp switch signal circuit.
Action Taken When the DTC Sets
* The BCM stores the DTC to memory.
* The Service Vehicle Soon indicator is commanded ON.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Circuit/System Verification
Ignition ON, press and release the brake pedal. The stop lamps should illuminate then go out.
Circuit/System Testing
1. Ignition OFF, disconnect the X1 harness connector at the ECM.
2. Disconnect the harness connector at the TCM.
3. Connect a test lamp between the TCM signal circuit terminal 16 and ground.
4. Engine ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
^ If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit test normal, replace the BCM.
^ If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
5. Ignition OFF, connect the TCM.
6. Connect a test lamp between the ECM signal circuit terminal 7 and ground.
7. Engine ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
^ If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the TCM.
8. If all circuit tests normal, replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests