129. Crankshaft Balancer Installation

Crankshaft Balancer Installation


Tools Required
* EN 46106 Engine Flywheel Holding Tool
* J 41998-B Crankshaft Balancer Installer
* J 45059 Angle Meter






1. The EN 46106 must be installed onto the flywheel.
2. Use the J 41998-B , nut, bearing and washer to install the crankshaft balancer.





Important: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.


3. Apply lubricant to the inside of the crankshaft balancer hub bore.




4. Place the crankshaft balancer in position on the crankshaft.
5. Thread the J 41998-B in the crankshaft. Ensure you engage at least 10 threads of the J 41998-B before pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by tightening the nut on the J 41998-B until the large washer bottoms out on the crankshaft end.
7. Remove the J 41998-B.




8. Install the crankshaft balancer bolt.

Notice: Refer to Fastener Notice .

9. Tighten the crankshaft balancer bolt.

1. Tighten the crankshaft balancer bolt to 100 N.m (74 lb ft).
2. Tighten the crankshaft balancer bolt an additional 150 degrees using the J 45059.






10. Remove the EN 46106.