Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
Removal Procedure
1. Remove the engine mount strut and bracket.
2. Disconnect the engine wiring harness electrical connector (1) from the bank 1 intake camshaft position (CMP) sensor (2).
3. Remove the CMP sensor bolt and sensor (2).
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the CMP sensor (2) and bolt.
Tighten the bolt to 10 N.m (89 lb in).
2. Connect the engine wiring harness electrical connector (1) to the bank 1 intake CMP sensor (2).
3. Install the engine mount strut and bracket.