Body - Air Inlet Grille Panel Side Cowl Not Attached
TECHNICALBulletin No.: 09-08-111-006
Date: September 14, 2009
Subject: Air Inlet Grille Panel Side Cowl Not Attached to Fender (Clean and Reattach Panel to Fender)
Models:
2008-2009 Buick Enclave
Condition
Some customers may comment that the air inlet grille panel side cowl is not attached to the fender. This is located on driver side by the top of the fender and the lower windshield.
Correction
1. Verify the customer's concern.
2. Wipe both surfaces with an alcohol wipe or equivalent alcohol substance (1).
3. Apply Adhesive Promoter 3M #4298 or equivalent.
4. Apply Acrylic Tape 3M #06378 or equivalent. The acrylic tape should be applied no closer than 3 mm (0.12 in) from the top of the fender.
5. Apply roughly 10 lbs of force to the air inlet panel to ensure that the panel attaches to the fender.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer