B257A
DTC B257A
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC B257A 00
- Headlamp Switch Input Signal Mismatch
Diagnostic Fault Information
Circuit/System Description
When the headlamp switch is in the OFF position, the body control module (BCM) receives a ground signal through the headlamp switch OFF circuit and an open signal on the park lamp ON circuit and headlamps ON circuit. When the headlamp switch is in the PARK or HEAD position, the BCM receives an open signal through the headlamp switch OFF circuit and a ground signal through the park lamp ON circuit or headlamp ON circuit.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The BCM receives an unexpected signal along either the headlamp switch OFF circuit or the headlamp ON circuit.
Action Taken When the DTC Sets
The BCM disregards the headlamp switch input and defaults to automatic headlamp function.
Conditions for Clearing the DTC
The BCM clears this code from current when the fault is removed from the system.
Reference Information
Schematic Reference
* Headlights/Daytime Running Lights (DRL) Schematics (Headlights/Daytime Running Lights (DRL) Schematics)
* Exterior Lights Schematics (Exterior Lights Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Exterior Lighting Systems Description and Operation (Exterior Lighting Systems Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, headlamp switch to PARK, just the park lamps should illuminate.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the headlamp switch.
2. Verify that a test lamp illuminates between the ground circuit terminal 8 and B+.
• If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
3. Ignition ON, verify the scan tool Auto Hdlp. Disable Sw. parameter is Inactive.
• If not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal, replace the BCM.
4. Verify the scan tool Headlamp Switch parameter is Inactive.
• If not the specified value, test the signal circuit terminal 1 for a short to ground. If the circuit tests normal, replace the BCM.
5. Verify the scan tool Parklamp Switch parameter is Inactive.
• If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the BCM.
6. If all circuits test normal, test or replace the headlamp switch.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Headlamp Switch Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for BCM replacement, setup, and programming