Removal and Replacement

Throttle Body Assembly Replacement

Removal Procedure




1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (2) from the electronic throttle control (1).




3. Remove the throttle body bolts (3).
4. Remove the throttle body (2) and gasket (2). Discard the gasket.

Installation Procedure




1. Position a NEW throttle body gasket (1) and throttle body (2) to the upper intake manifold.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the throttle body bolts (3).

Tighten the bolts to 10 Nm (89 lb in).




3. Connect the engine wiring harness electrical connector (2) to the electronic throttle control (1).
4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Service and Repair).
5. Perform the throttle learn procedure. Refer to Throttle Learn (Programming and Relearning).