Fuel Pump: Service and Repair

Removal

1. Disconnect fuel inlet line from pump.
Disconnect vapor return hose, if so equipped.
2. Remove two bolts holding fuel pump.
3. Remove fuel pump, push rod, gasket and mounting plate (if used).

Installation

1. Install push rod, gasket, mounting plate (if used) and fuel pump.
2. Install two hex head bolts, turning them alternately and evenly.
3. Install fuel outlet pipe. If it is difficult to start fitting, time can be saved by disconnecting upper end of pipe from carburetor. Tighten fitting securely, meanwhile holding fuel pump nut with a wrench. Install and tighten fitting at carburetor, if removed.
4. Install fuel inlet hose and clamp. Install vapor return hose and clamp, if so equipped.
5. Start engine and check for leaks.