Assemble

1. Press output shaft bearing onto output shaft using tool No. J6133-A or equivalent.




2. Position 1st gear onto shaft. Place blocker ring onto gear cone, then press 1-2 synchronizer on the shaft using a piece of pipe of suitable diameter or other suitable tool. Do not press on sleeve, press on hub near shaft.

3. Install snap ring retaining 1-2 synchronizer, then place blocker ring into position.




4. Position 2nd gear onto shaft, then press 3rd gear onto shaft with gear hub facing toward fourth gear. Use a piece of pipe of suitable diameter or other suitable tool to press on 3rd gear hub near shaft.

5. Install snap ring retaining 3rd gear.




6. Press 4th gear onto shaft, with hub facing toward 3rd gear using support plates. Install output shaft bearing onto shaft using tool No. J-26942.