Landau Roof Molding, Quarters & Rear Belt Reveal Molding

FIGURE 2 - ROOF MOLDING INSTALLATION:

LANDAU ROOF MOLDING (LEFT OR RIGHT)

Removal

1. Tape protective covering to adjacent painted surfaces to prevent paint damage.

2. Remove screws securing left or right roof molding to door pillar and pull molding straight out from clips on roof panel (Fig. 2).

Installation

1. Slide molding onto clips on roof panel.

2. Install screws securing roof molding to pillar.

FIGURE 1 - VINYL TOP MOLDINGS:

QUARTER BELT CORNER MOLDING - (LEFT OR RIGHT)

Removal

1. Tape protective covering to adjacent painted surface to prevent paint damage.

2. Using pry tool, work quarter belt reveal molding (6, Fig. 1) from barrel nuts in panel.

3. Using pry tool, work rear belt reveal molding (2 or 4, Fig. 1) from barrel nuts in panel.

4. Using a 3.5 mm (9/64") drill with a 9.5 mm (3/8") drill stop, drill out rivets in quarter belt corner moldings (5, Fig. 1).

5. Quarter belt corner moldings.
Installation

1. Align quarter belt corner molding with previous attaching holes and secure with closed-end rivets.

2. Align rear belt reveal molding clips with barrel nuts in panel and secure by lightly tapping molding into place with rubber mallet.

3. Align quarter belt reveal molding clips with barrel nuts in panel. Secure by lightly tapping molding with rubber mallet.


REAR BELT REVEAL MOLDING (LEFT OR RIGHT)

Removal

1. Tape protective covering to adjacent painted surfaces to prevent paint damage.

2. Using pry tool, work rear belt reveal molding (2 or 4, Fig. 1) from barrel nuts.

3. Remove rear belt reveal molding and molding clips.

Installation

1. Install clips to molding.
2. Align molding clips with barrel nuts in panel and secure by lightly tapping molding into place with rubber mallet.

QUARTER BELT REVEAL MOLDING (LEFT OR RIGHT)

Removal

1. Tape protective covering to adjacent painted surfaces to prevent paint damage.

2. Using pry tool, work quarter belt reveal molding (6, Fig. 1) from barrel nuts.

3. Remove quarter belt reveal molding and molding clips.


Installation

1. Install clips to molding.

2. Align molding clips with barrel nuts in panel and secure by lightly tapping molding into place with rubber mallet.