Assembly Instructions

FOR INSTALLATION OF ANTI-ROTATION CLIPS TO FACTORY MOUNTED BRACKETS

CAUTION: ANTI-ROTATION SPRING

CLIPS MUST BE INSTALLED PRIOR TO

INSTALLATION OF WHEEL COVER.

1985 C ANTI-ROTATION CLIP INSTALLATION:

ANTI-ROTATION CLIPS SHOULD BE INSTALLED INTO FLAT AREAS OF LOCK BRACKETS. (FIG. 1).

1985 C ANTI-ROTATION CLIP INSTALLATION:

INSERT LEADING TAB OF ANTI-ROTATION CLIP INTO LONG SLOT ON BRACKET. (SEE ARROW IN FIG. 2).

1985 C ANTI-ROTATION CLIP INSTALLATION:

WITH LEADING TAB INSERTED SWING ANTIROTATION CLIP IN DIRECTION OF ARROW. (TOWARD WHEEL) SNAP TAB MUST ALIGN WITH ELONGATED HOLES ON BRACKET.. INSERT SNAP TABS BY PUSHING ON BASE OF ANTI-ROTATION CLIP. (SEE ARROW IN FIG. 4).

REPEAT INSTRUCTIONS FOR EACH OF THE 3 CLIPS ON ALL 4 OF THE WHEELS.

AFTER ALL CLIPS ARE INSTALLED SECURELY

PROCEED TO STEP 2.

1985 C WIRE WHEEL COVER INSTALLATION
1. INSTALL ANTI-ROTATION CLIPS INTO LOCK BRACKETSSEE ANTI-ROTATION CLIP INSTALLATION ON BACK OF THIS SHEET, THESE CLIPS MUST BE INSTALLED FOR PROPER RETENTION OF COVER TO WHEEL. SEE ILLUSTRATION ON NEXT PAGE.
2. REMOVE 3 OF THE 5 STANDARD LUG NUTS TO MATCH PATTERN OF LOCK BRACKET. SEE FIGURE 1 FOR STEPS 2 THROUGH 7.

3. PLACE LOCK BRACKET OVER 3 MOUNTING STUDS.
4. SECURE WHEEL AND THE LOCK BRACKET WITH SPECIAL LUG NUTS AS SHOWN. TIGHTEN ALL NUTS TO TORQUE SPECIFIED IN OWNERS MANUAL.
5. PLACE WHEEL COVER ON WHEEL, ALIGN VALVE HOLE IN WHEEL COVER WITH VALVE ON WHEEL. PUSH WHEEL COVER ONTO WHEEL BY HAND, DO NOT USE HAMMER OR MALLET TO INSTALL COVER.
6. TIGHTEN LOCKNUT BY TURNING WRENCH CLOCKWISE UNTIL NUT BOTTOMS OUT. THIS WILL SECURE COVER.
7. SNAP MEDALLION INTO CENTER OF COVER.
8. STORE WRENCH IN GLOVE BOX.
9. TO SERVICE OR REPAIR. FOLLOW WIRE WHEEL COVER REMOVAL INSTRUCTIONS.

A, B, E, G, J & X MODELS WIRE WHEEL COVER INSTALLATION:

1. REMOVE THREE (3) LUG NUTS TO INSTALL LOCK BRACKET ON WHEEL
2. REPLACE LUG NUTS TORQUE TO SPEC.
3. MOUNT WHEEL COVER
4. REMOVE CENTER MEDALLION
5. TIGHTEN LOCK BOLT
6. REPLACE CENTER MEDALLION
7. PLACE LOCK WRENCH IN GLOVE BOX 8 INSTALL WHEEL COVER REMOVAL LABEL NEXT TO JACKING INSTRUCTION LABEL
NOTE: LOOSE CONDITION OF LOCK BRACKET WILL BE NORMAL