Front Seat Cushion - Hard/Too Firm

Bulletin 87-10-7

Date Feb. '87

Ref. No. 87-074-10

Corp. Ref. No. 701004
SUBJECT: FRONT SEAT DISCOMFORT

MODELS AFFECTED: LESABRE, 1986 AND EARLY 1987, INTO JANUARY PRODUCTION
If a comment on firm or hard front seat cushion is received, the following procedure can be used to soften either driver or passenger side:

FRONT SEAT CUSHION:

^ See Illustrations.
^ Determine if correction has already been done, reach under seat to check if center element (spring) is present. If so, continue to next step.

^ Remove front seat.

^ Detrim seat bottom, front and sides. It is not necessary to remove adjusters.

^ Remove two (2) hog rings from rear of seat trim, to gain access to rear of element.

^ Remove front and rear clips from center element.

^ Open attaching tabs on seat frame, at ends of element.

^ Remove element only from side which condition exists.

^ Retrim seat.

^ Reinstall seat.
WARRANTY INFORMATION:

Labor Operation Numbers:

Split Seat, (each side) Bench, (for one [1] side) Both Sides
T5135 T5136 T5137

Labor Time, Split Seat: .7 for each side
Bench Seat: .7 for one (1) side .8 for both

Trouble Code: 92