Preparation

1. After the repaired or replacement transmission is installed in the vehicle, do not reconnect the oil cooler pipes.

2. Remove the fill cap on J 35944 and fill the can with 0.6 L (20-21 oz.) of flushing solution. Do not overfill.

3. Install the fill cap on J 35944 and pressurize the flusher can using the shop air supply to 550-700 kPa (80-100 psi).

4. Connect the J 35944 discharge hose to the oil cooler return pipe (refer to Table 1). Use J 35944-200 or J 35944-440 if required.

5. Clip the discharge hose onto the oil drain container.

6. Attach J 35944 to the undercarriage of the vehicle with the hook provided and connect the hose from J 35944 to the other (feed) oil cooler pipe. Use J 35944-200 or J 35944-440 if required.

7. With the water valve on J 35944 in the "OFF" position, connect the water hose from the water supply to J 35944.

8. Turn "ON" the water supply at the faucet.