Fluid Change

1. Raise and support vehicle, then position drain pan under oil pan.

2. Remove front and side oil pan attaching bolts, then loosen rear pan attaching bolts.

3. Carefully pry pan loose from transaxle case and allow fluid to drain.

4. Remove remaining attaching bolt, oil pan and gasket. Thoroughly clean pan before reinstalling.

5. Remove and discard screen and O-ring seal.

6. Install replacement screen and O-ring seal, locating screen against dipstick stop.

7. Install gasket on oil pan, then install pan and torque attaching bolts to 8 ft lbs..

8. Lower vehicle and add specified amount of fluid.

9. With selector in park, parking brake applied and engine at idle speed and operating temperature, check fluid level and add fluid as necessary. Do not race engine. On THM 125 models, leave shift lever in "Park" position; on THM 125C models, move shift lever through ranges, then back to "Park" position.