Installation

Install or Connect

1. Loosen the pinch bolt on the new sensor pedestal until the sensor is free to slide in the pedestal.
2. Verify that the window in the interrupter is still properly positioned and install sensor and pedestal as a unit while making sure that the interrupter ring is aligned within the proper slot.
3. Install pedestal to engine mounting bolts and torque to 30 Nm (22 lb ft).
4. Replace lower wheelhouse to engine compartment bolt and reinstall right lower filler panel.

Adjust

1. Loosen the pinch bolt on sensor pedestal and insert adjustment tool (J36179 or equivalent) into the gap between sensor and interrupter on each side of interrupter ring.
2. Be sure that interrupter is sandwiched between blades of adjustment tool and both blades are properly inserted into sensor slot.
3. Torque sensor retaining pinch bolt to 3.4 Nm (30 lb in) while maintaining light pressure on sensor against gage and interrupter ring. This clearance should be checked again, at three positions around the interrupter ring, approximately 120° apart. If interrupter ring contacts sensor at any point during harmonic balancer rotation, the interrupter ring has excessive runout and must be replaced.