Service Procedure

1. Make sure the ignition is in the "OFF" position and ignition key is removed.

2. Remove right hand hush panel (kickpad).

3. Disconnect connectors to Electronic Control Module (ECM) and remove ECM.

4. Remove PROM access cover.





5. Remove PROM assembly using the rocker-type PROM removal tool. See Figure 1

NOTICE:
Using the rocker-type PROM removal tool, engage one end of the PROM carrier with the hook end of the tool. Press on the vertical bar end of the tool and rock the engaged end of the PROM carrier up as far as possible. Engage the opposite end of the PROM carrier in the same manner and rock this end up as far as possible. Repeat this process until the PROM carrier and PROM are free of the PROM socket. The PROM carrier with PROM in it should lift off of the PROM socket easily. PROM carrier should only be removed by using the pictured PROM removal tool. Other methods could cause damage to the PROM or PROM socket.

6. Install new PROM assembly in ECM.





NOTICE:
Small notch of PROM carrier should be aligned with small notch in ECM socket. Press on PROM carrier until it is firmly seated in the socket. Do not press on PROM, only on the carrier (See Figure 2).


7. Reverse Steps 4 through 2 to reinstall ECM.

8. Start the engine and observe check engine light. If it does not go out, the PROM was installed backwards and is now damaged; a new PROM will have to be installed in the correct orientation.

9. Open hood and install Campaign Identification Label. Close hood.