Snapshot Mode

Selection of the "BCM SNAPSHOT?" test will result in the message "SNAPSHOT TAKEN" being displayed. This message will appear for 3 seconds to indicate that all BCM data and inputs have been stored in memory. After 3 seconds the display will automaticaly proceed to "BCM SNAP DATA?".
While selecting a snapshot test type, any of the following actions may be taken to control the display.

1. Depressing the " EXIT" button on the CRT will stop the test type selection process and return the display to the next available system selection, which will be "CRT?".

2. Depressing the "NO" button will display the next available snapshot test type. This allows the display to be stepped through all available choices. This list of snapshot test types can be repeated following the display of the last choice.

3. Depressing the "YES" button with "BCM SNAPDATA?" or "BCM SNAP SHOT?" displayed will select that test type. At this point the display is controlled as it would be for non-snapshot data and inputs displays, however, all values and status information represents memorized vehicle conditions.

4. Depressing the "YES" button with "BCM SNAPSHOT?" displayed will again display the "SNAPSHOT TAKEN" message to indicate that new information has been stored in memory. Access to this information is obtained the same as previously described.