Instrument Panel - Noise Coming From Center Area
88buick20Bulletin: 88-10-39
Date: Sept. '88
Ref. No.: 88-187-10
Corp. Ref. No.: 871201R
SUBJECT: RATTLE OR BUZZING NOISE COMING FROM CENTER AREA OF INSTRUMENT PANEL
MODELS AFFECTED: 1987-1988 SKYHAWKS WITH C60 A/C
1987 SOMERSETS WITH C60 A/C
1987-1988 SKYLARKS WITH C60 A/C
Some owners of the above models may comment on a metallic rattle or buzzing noise coming from center of the instrument panel.
Under certain road or engine load conditions, with the A/C system on, the metal defroster valve in the A/C module assembly may vibrate against the plastic case causing the noise. The noise may be heard in all modes except defrost.
The procedure outlined below should be followed to address this condition:
FIGURE 1A - SKYHAWK INSULATOR:
FIGURE 1B - SKYLARK INSULATOR:
CORRECTION
1. Remove right side insulator assembly (See Figures 1A & 1B).
FIGURE 2 - AIR OUTLET DUCT:
2. Remove duct assembly, floor air outlet (See Figure 2).
3. Secure a 1" long piece of 7/16" windshield washer hose (or equivalent) and cut one side the full 1" length so that the hose can be slipped over the edge of the defroster valve.
4. Apply RTV silicone rubber adhesive sealant to the inside of the 1" piece of rubber hose.
5. Set mode lever on control pane to defrost position. This will expose the edge of the defroster valve.
FIGURE 3 - INSTALLATION OF 1" HOSE:
6. Reach through the duct opening in the module assembly and push the 1" piece of hose with sealant onto the exposed edge of the metal defroster door (See Figure 3).
CAUTION: Ample cure time for RTV sealant must be allowed to ensure rubber hose adheres to the valve.
7. Reassemble floor air outlet duct assembly and right side insulator assembly.
WARRANTY INFORMATION
Labor Operation Number: T4636
Labor Time: .4 Hours
Trouble Code: 92