Operation CHARM: Car repair manuals for everyone.

Fuel Tank - Underbody Creak/Groan Noise


91buick07

Bulletin: 91-10-34

Date: Oct. '91

Ref. No.: 91-266-10

Corp. Ref. No.: 136304


SUBJECT: FUEL TANK/UNDERBODY CREAK/GROAN NOISE (SERVICE PROCEDURE FOR INSTALLING FUEL TANK STRAPS AND SPACERS)

MODELS AFFECTED: 1989-91 REGALS


This bulletin cancels and supersedes Buick Bulletin 91-10-20. Additional information and part numbers are provided to address another fuel tank related noise condition.

CONDITION:

Some 1989-91 Regals may exhibit a creak/groan or in severe instances a clunk/thud type noise coming from the rear of the vehicle. This noise is most apparent when a vehicle twisting motion is generated, such as that which would be experienced when turning up a steep incline/driveway.

CAUSE:

These noise conditions may be caused by the fuel tank flange contacting the underbody crossbar located forward of the fuel tank or movement between the tank and retaining straps.

CORRECTION:

On 1989-91 Regals assembled prior to VIN M1848929, install new fuel tank straps, P/N 10199250 (2 required), and strap spacers, P/N 10192675 (2 required).

On 1991 vehicles assembled after VIN M1848929, it will only require installation of tank straps, P/N 10199250 (2 required) and the transfer of existing strap spacers.

SERVICE PROCEDURE:

1. Raise vehicle on hoist.

2. Remove exhaust intermediate pipe heat shield.

3. Support fuel tank assembly.





4. Remove RH fuel tank strap attaching bolts/screws, remove spacer from strap if present, discard strap.

5. Install strap spacer, P/N 10192675, on new strap, P/N 10199250, as shown on Illustration.

Parts are currently available from GMSPO.

NOTICE: DO NOT BEND FUEL TANK STRAPS, AS THIS MAY DAMAGE STRAPS.

6. Position strap and loosely install attaching bolts/screws.

7. Repeat steps 4 thru 6 for LH strap.

8. Insuring a minimum of 4 mm of clearance is maintained between fuel tank flange and underbody bar, torque attaching bolts/screws to 40-54 N-m (29-39 lbs.ft.).

9. Install exhaust heat shield and torque bolts/screws to 2 N-m (1.5 lbs.ft.).

10. Remove support from under fuel tank and lower vehicle.

WARRANTY INFORMATION:

Labor Operation Number: T1677
Labor Time: .4 Hours