Service Procedure

1. Move driver side front seat to full rearward position. On a 6-way power seat, also move to the full up position.

2. Remove front track covers and adjuster to floor pan bolts.

3. Move seat to full forward position.

4. Remove rear track covers and adjuster to floor pan bolts.





5. Tilt seat completely back so entire area under seat cushion is visible (see illustration).

6. Cut and remove strap attaching wiring harness to spring wire near middle of seat.

7. Inspect wiring harness. Make repairs as necessary with electrical tape.

8. Install wiring harness to clip.

9. Reroute wiring harness through detent and insert clip into forward most hole in seat cushion frame (see illustration). HARNESS MUST NOT BE PINCHED BETWEEN CUSHION AND SPRING OR CONTACT SHARP EDGES.

10. Tilt seat back to original position and align.

11. Install adjuster to floor pan bolts. Torque to 24 N-m (18 lb.ft.).

12. Install track covers.

13. Repeat for opposite front seat if applicable.

14. Install Campaign Identification Label.