D: Fuel Gage Accuracy Test

Open the Fuel Gage Sender connector and connect the two red clip leads to tester J-33431 to terminals E (BLK/WHT) and B(PPL) of the harness half of that connector. With Ignition in RUN, set the resistance dial on the tester to 0 ohms (E) and to 90 ohms (F). Observe the Fuel Gage (Fuel Gage will not respond instantly due to Anti-Slosh Device).

^ If the Gage responds correctly, install a new Fuel Gage Sender.

^ If the Gage does not respond correctly, check PPL (30), BLK (151) and BLK/WHT (353) wires for high resistance. If all checks are OK, replace the Instrument Cluster (see Service and Repair).