Rear Suspension

1. Raise rear of vehicle and support rear axle under front side of spring seat using a suitable jack.
2. Remove stabilizer bar from axle.
3. Remove wheel and tire assembly.
4. If right hand side bushing is to be replaced, disconnect brake line bracket from body. If left hand side bushing is to be replaced, disconnect brake line bracket from body and parking brake cable at hook guide.
5. Remove control arm to mounting bracket attaching nut, bolt and washer, then allow control arm to rotate downward.
6. Reverse procedure to complete installation.

Note: The control arm attaching bolt must be torqued after vehicle is lowered to floor and is in its standing height position. Torque attaching bolt to specifications.