Regulator Tape

Important
^ When cutting service tape, it is necessary to cut tape so that there is a half a notch at each end of the tape. This is done to insure proper indexing of the tape when installed. Tape lengths are as follows:
^ 2 Door Front Door Manual 1 190.7 mm (46.87") 146 full holes plus 1/2 hole each end.
^ 2 Door Front Door Electric 1 044.7 mm (41.13") 128 full boles plus 1/2 hole each end.
^ 4 Door Front Door Manual 1 287.9 mm (50.70") 158 full holes plus 1/2 hole each end.
^ 4 Door Front Door Electric 1 142.1 mm (44.96") 140 full holes plus 1/2 hole each end.

Remove or Disconnect

1. Inner belt sealing strip.
2. Trim panel.
3. Water deflector.
4. Regulator.
5. Run tape from regulator.

Install or Connect

1. Cut service tape to size.
2. Guide on tape in first three notches.
3. Tape and guide through regulator channel.
4. Regulator.
5. Water deflector.
6. Trim panel.
7. Inner belt sealing strip.