Part 2 of 2

Chart C-10 Part 2 Of 2:

Chart C-10 Wiring Diagram:

CIRCUIT DESCRIPTION:




The A/C clutch control relay is energized when the ECM provides a ground path through CKT 459 and A/C is requested. A/C clutch is delayed about 0.3 seconds after A/C is requested. This will allow the IAC to adjust engine rpm for the additional load.

The ECM will temporarily disengage the A/C clutch relay for calibrated times for one or more of the following:

^ Hot engine restart.
^ Wide open throttle (TPS over 90%).
^ Power steering pressure high.
^ Engine rpm greater than about 6000 rpm.
^ During IAC reset.

The A/C clutch relay will remain disengaged when a Code 66 is present, if pressure is out of range or there is no A/C request signal due to an open A/C select switch or circuit.


TEST DESCRIPTION: Numbers below refer to circled numbers on the diagnostic chart.

3. Checks for a faulty relay.