General

1. Check the WIPER Fuse by visual inspection.
2. Check that the Wiper/Washer Switch connectors are mated correctly.
3. If Wipers cycle in and out of Park Position in HI, and do not operate in LO, MIST or PULSE, check YEL (196) wire for an open.
4. If the Wiper Motor runs but the wiper blades do not, check the wiper linkage at the wiper crank arm.
5. If the Washer does not operate, check that:
- Washer connector is correctly mated.
- Washer reservoir is filled.
- Hoses are not pinched or kinked.
- Hoses are correctly attached.
- Nozzles are not clogged.
6. If Washer operates continuously, check the RED (228) and PNK (94) wires for a short to battery. If OK, check for a poor connection. If OK, replace the Wiper/Washer Switch.
7. If Wipers work in LO, but not in MIST, check for a poor connection. If OK, replace the Wiper/Washer Switch.