Engine Installation

INSTALL OR CONNECT
1. Lower engine assembly.
2. Engine to transaxle bolts.
- Tighten bolts to 75 Nm (55 lbs.ft.).
3. Right front engine to transaxle bracket.
4. Front engine mount.
- Tighten engine mount to engine bolts to 95 Nm (70 lbs.ft.).
- Tighten to engine mount nuts to 41 Nm (30 lbs.ft.).
5. Torque converter to flywheel bolts with converter to flywheel in same relationship as before disassembly.
- Tighten Converter to flywheel bolts to 62 Nm (46 lbs.ft.).
6. Flywheel cover.
- Tighten bolts to 6 Nm (53 lbs. in.).
7. Engine oil cooler lines, if equipped.
8. Air conditioner compressor.
9. Cruise control, vacuum hoses at servo assembly.
10. Exhaust pipes to right manifold.
11. Wiring harness connectors to:
- Manifold Absolute Temperature (MAT) sensor.
- Throttle position sensor.
- Idle air control valve.
- Oxygen sensor.
12. Throttle cable to throttle linkage, mounting bracket and also other applicable cables.
13. Air flow duct and air cleaner mountings.
14. Power steering pump to engine.
- Tighten Power steering pump bolts 27 Nm (20 lbs.ft.).
15. Main wiring harness to engine and battery connectors located behind the relay housing.
16. Wiring to starter.
17. Windshield washer, radiator and heater supply hoses.
18. Radiator hoses.
19. Add coolant and engine oil.
20. Battery leads.
21. Check for:
- Oil level
- Fluid levels
- Fluid leaks
- For proper completion of repairs