Procedure For Cowl Plenum Seam (See Figure 1)

1. Open and raise the hood to the full open position.
2. Remove the left wiper arm and blade.
3. Remove the left side cowl grille (See Figure 1, View A).
4. Using the material and equipment specified, apply sealer to the seam areas through the rectangular holes in the cowl as shown in Figure 1, Views B and C.

Apply this sealer for the full length of the cowl seam from the center line of the vehicle to the left edge of the cowl plenum.

5. Allow the sealing material to dry for 15 minutes before applying second coat.

NOTE:
Allow sealer to dry completely before water testing.

6. Reinstall the left cowl grille and wiper components.
7. Torque wiper arm attachment to 23 N-m (17 lb.ft.).