Ignition Control Module: Service and Repair

Distributor Disassembly:

1. Remove distributor cap and rotor.
2. Remove two module attaching screws, and lift module up.
3. Disconnect leads from module.
4. Remove module.

NOTE: Be sure there is a sufficient amount of silicone grease on the metal face of the module and on the distributor base (where the module seats), when reinstalling the module. The purpose of the silicone grease is to cool the module.

5. Install module.
6. Connect leads to module.
7. Install module attaching screws.
8. Install cap and rotor.