Ignition Lock Cylinder

Fig. 1 Ignition Lock Installation:

1. On models equipped with airbags, disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING then remove steering wheel as described under STEERING SUSPENSION CHASSIS AND BODY COMPONENTS/STEERING/COMPONENT REPLACEMENT AND REPAIR PROCEDURES.
2. On all models, remove turn signal switch as described under TURN SIGNAL REPLACE, then remove buzzer switch.
3. Place ignition switch in Run position, then remove lock cylinder retaining screw and lock cylinder.
4. Install by rotating lock cylinder to stop while holding housing, Fig. 1. Align cylinder key with keyway in housing, then push lock cylinder assembly into housing until fully seated.
5. Install lock cylinder retaining screw.
6. Install buzzer switch, turn signal switch and steering wheel.
7. Rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING