Label Installation Procedure
1. Open driver's door.
2. Verify that the Vehicle Identification Number (VIN) of the new certification label is the same as the existing label (see illustration) for location.
If the VIN of the new certification label is different than the existing label, contact the Zone/Branch to arrange to receive the correct label.
If the VIN of the new certification label is the same as the existing label, follow the remaining steps of this procedure and install the new label.
3. Clean the surface of the old label with soapy water and wipe dry.
4. Remove protective backing from new label, and carefully apply to vehicle over old label.
DO NOT ATTEMPT TO REMOVE OR LOOSEN THE NEW LABEL ONCE IT HAS BEEN APPLIED, AS THIS WILL DAMAGE THE LABEL AND MAKE IT ILLEGIBLE.
5. Install Campaign Identification Label
CAMPAIGN IDENTIFICATION LABEL
Each label provides a space to include the CAMPAIGN NUMBER, the five (5) digit dealer code of the dealer performing the campaign service, and the date vehicle was campaigned. This information may be inserted with a typewriter or ballpoint pen. When installing label, clean the surface of the radiator support tie bar and apply the campaign label where it is readily visible.
WARRANTY INFORMATION
Dear Buick Park Avenue/Ultra Owners:
General Motors has determined that some 1992 Buick Park Avenue/Ultra model vehicles were produced at the Wentzville Assembly plant with incorrect certification labels. The vehicle certification label located on the driver door of these vehicles was printed with "03/91" in the "date" (month/year of manufacture) space rather than the correct "03/92" date.
WHAT WE WILL DO
To correct this condition, a new label is to be affixed to each affected vehicle. We have enclosed a new label for your vehicle. You may install this label yourself or take the label and your vehicle to a Buick dealer for installation at no charge to you.
WHAT YOU SHOULD DO
Instructions for installing this label are given on the back side of this letter. The time to install the new label is approximately five (5) minutes.
If you install the new label, rather than asking your dealer to do it, or if you have sold or traded your vehicle, please let us know by completing the postage paid owner reply card and returning it to us. This will assist us in assuring that all affected vehicles have been corrected and also will eliminate the necessity for bothering you with follow-up notifications.
We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your continued satisfaction with our products.
CERTIFICATION LABEL INSTALLATION PROCEDURE
1. Open driver's door.
2. Locate the certification label (see illustration).
3. Verify that the Vehicle Identification Number (VIN) of the new certification label is the same as the existing label.
If the VIN of the new certification label is different than the existing label, contact your Dealer to arrange to receive the correct label.
If the VIN of the new certification label is the same as the existing label, follow the remaining steps of this procedure and install the new label.
4. Clean the surface of the old label with soapy water and wipe dry.
5. Remove protective backing from new certification label enclosed, and carefully apply to vehicle over old label.
DO NOT ATTEMPT TO REMOVE OR LOOSEN THE NEW LABEL ONCE IT HAS BEEN APPLIED AS THIS WILL DAMAGE THE LABEL AND MAKE IT ILLEGIBLE.
6. Fill out the enclosed postage paid owner reply card and drop it in the mail.