Bumper - Rear Facia Lower Edge Wavy

Bulletin:
93-2-1

Date:
Nov. '92

Ref.No.:
93-26-2

Corp.Ref.No.:
202002



SUBJECT:
REAR FASCIA LOWER EDGE WAVY

MODELS AFFECTED:
1992-93 LESABRE


CONDITION:

Some of the 1992-93 LeSabre models may exhibit a wavy appearance on the rear fascia lower edge.

CORRECTION:

To correct this condition, a molding kit, part number 25616605 has been released. The kit includes five (5) parts of three (3) different lengths. The different lengths are necessary due to the retaining tabs on the fascia.





Begin by installing the shortest molding (125 mm or approximately 5 inches) in the center of the fascia. On either side of the center molding, install the next shortest moldings (175 mm or approximately 6-7/8 inches) just past the fascia retaining tabs. The remaining moldings are then installed between the outboard fascia retaining tabs. (see illustration).

Parts are currently available from GMSPO.

WARRANTY INFORMATION:

Labor Operation No.: T5333
Labor Time: 0.2 hr.