Keyless Entry: Description and Operation

CIRCUIT OPERATION

The Remote Keyless Entry (RKE) Control System allows the driver to operate the vehicle Door Locks and Trunk Lid Release from outside the vehicle using a hand held Radio Transmitter. The Transmitter operates in the UHF band; it sends coded signals to the Keyless Entry Receiver. The Keyless Entry Receiver detects and decodes the signals and issues signals to control the Door Locks and Trunk Lid Release. These systems can also be operated in the usual manner; for instance, the Door Locks will respond to the Power Door Lock Switches.

LOCK
When the "DOOR" Button is pressed on the Transmitter and the Keyless Entry Receiver receives a signal with a valid Vehicle Access Code (VAC), the Lock function sequence is performed. The Keyless Entry Receiver will lock all doors.

The Keyless Entry Receiver supplies battery voltage to the coil of the Lock Relay. The Lock Relay is energized, and battery voltage is supplied to the Door Lock Motors. Ground for the LH Door Lock Motor is provided at Keyless Entry Receiver terminal "B" through internal contacts. Ground for the other Door Lock Motor(s) is provided through the contacts of the Unlock Relay of the Power Door Lock Relay. All Door Lock Motors run to lock all doors.

UNLOCK
The Unlock function is separated into two operations depending on how the "UNLOCK" Button is pressed on the Transmitter. If the "UNLOCK" Button is pressed once, only the LH Door is unlocked. If the "UNLOCK" Button is pressed twice within 1 to 5 seconds, all doors will be unlocked.

When the Unlock Button is pressed once on the Transmitter and the Keyless Entry Receiver receives a signal with a valid VAC, the Unlock function sequence is performed. The Keyless Entry Receiver will supply battery voltage to the LH Door Lock Motor via the TAN (694) wire. The motor is grounded through the contacts of the Lock Relay in the Power Door Lock Relay. The LH Door Lock Motor runs to unlock the LH Door.

If the "UNLOCK" Button on the Transmitter is pressed twice to unlock all doors, the Keyless Entry Receiver will activate the Door Unlock output at pin G. The Keyless Entry Receiver will then supply battery voltage to the coil of the Unlock Relay in the Power Door Lock Relay. The Unlock Relay is energized and closes its contacts. Battery voltage is supplied to all Door Lock Motors except the LH Front. The motors are grounded through the contacts of the Lock Relay in the Power Door Lock Relay. The motors run to unlock the doors.

TRUNK LID RELEASE
When the Trunk Lid Release Button is pressed on the Transmitter and the Keyless Entry Receiver receives a signal with a valid VAC, the Keyless Entry Receiver will supply battery voltage at its terminal "H". This battery voltage is then applied to the Trunk Lid Release Solenoid. The Trunk Lid Release Solenoid is energized and the Trunk Lid can be opened. If the Ignition Switch is "ON" and the Transaxle Position Switch is not in "PARK," battery voltage is not supplied to Keyless Entry Receiver terminal "D" and the Trunk Lid will not open.

ILLUMINATED ENTRY
When the RKE System Unlock function is used (driver's door only or all doors), the Keyless Entry Receiver lights the interior lights by grounding CKT 156. The interior lights will remain on for approximately 40 seconds, or until the Ignition Switch is turned to "RUN."

When the Lock function is used, the Keyless Entry Receiver lights the interior lights for 2 seconds by grounding CKT 156 as a signal that the doors have been locked.