Component Tests and General Diagnostics

1. Check TRUNK REL Fuse by visual inspection.
2. Always check terminal contact before replacing any component.
3. Be certain to verify proper Power Door Lock function before beginning Keyless Entry diagnosis. See "Automatic Door Locks."
4. Be certain to verify proper Trunk Lid Release function before beginning Keyless Entry diagnosis. See "Trunk Lid Release."
5. If door locks operate from the Transmitter, but not from the Door Lock Switches, check continuity of Door Lock Switch and associated wiring for an open or a short. Repair/replace as necessary.
6. If a second Transmitter is available, try it. If it works, replace the batteries in the first Transmitter and try it again. If it still doesn't work, it is defective.
7. Check Portable Transmitter Battery terminals. They should be clean and make good contact with the Battery.
8. If in doubt as to the condition of the Transmitter batteries, replace them with new ones. Measuring battery voltage with a DVOM may show a weak Battery as being good.

^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check.
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.