Remove Transaxle Case Side Cover

Case Side Cover, Oil Pump, And Control Valve Body.:

Case Side Cover View

Transaxle Brackets - 4T60-E (3.1L Engine):

Transaxle Bracket - 3.1L Engine Shown

Transaxle Mount - 4T60-E:

Transaxle Mount

Transaxle To Engine Brace:

Transaxle to Engine Brace - 2.2L, 3.1L Shown, Others Similar

Auxiliary Oil Cooler - 4T60-E:

Auxiliary Oil Cooler

Engine Support Fixture - 2.2L Engine:

Engine Support Fixture Installation - 3.1L Engine:

Engine Support Fixture - 3800 Engine:

Engine Support Fixture J-28467 Hookup (2.2L, 3.1L, & 3.8L)




REMOVE OR DISCONNECT

NOTE: Tool Required: J-28467-A, J-28467-90 Engine Support Fixture and J-36462 engine support adapter leg.

1. Negative battery cable, air cleaner assembly and Crossover pipe.
2. Shift cable clip at lever and mount bracket.
3. Install J-28467-A, J-28467-90, and J-36462.
4. Bolt/screw at top of transaxle mount bracket.
5. Raise vehicle, assure suitable support.
6. Left front wheel.
7. Left inner fender splash shield.
8. Transaxle mount.
9. Loosen engine mount nuts at frame.


CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or Intermediate steering control which could result in personal injury.

10. Pinch bolt at intermediate steering shaft.
11. Ball joints at steering knuckle.
12. Support right and left sides of frame with jackstands.
13. Left side frame to body bolts/screws.
14. Loosen right side frame to body bolts/screws.
15. Left side steering rack bolt/screw.
16. Wiring harness.
17. Left drive axle.
18. Transaxle mount bracket.
19. Position pan under transaxle.
20. Bolts/screws and nuts.
21. Case side cover and pan.


CLEAN AND INSPECT:
^ Case and side cover gasket surfaces.