Coupe

Tool Required:
J 24595-C Door Trim Pad and Garnish Clip Remover

Remove or Disconnect

1. Escutcheon cover.
2. Screws and seat belt from shoulder belt escutcheon.
3. Pull handle screws.
4. Retractor cover.
5. Handle bezel.
6. Power window and door switch assembly.
7. Bracket screw, sedan only, from switch cutout.
8. Screw from trim panel, coupe only.
9. Door trim panel using J 24595-C to disengage fasteners on trim panel from the holes in door inner panel.

Install or Connect

1. Wire harnesses through openings in trim panel.
2. Trim panel to door by aligning fasteners on trim panel to holes in door inner panel and pressing trim panel to door until fasteners are fully engaged.
3. Screw to trim panel, coupe only.

Tighten
^ Screw to 1 N.m (9 lb in).

4. Bracket screw, sedan only, through switch cutout.

Tighten
^ Screw to 2 N.m (18 lb in).

5. Power window and door switch assembly.
6. Inside handle bezel.
7. Retractor cover.
8. Pull handle screws.

Tighten
^ Screws to 3 N.m (27 lb in).

9. Seat belt and screws to shoulder belt escutcheon.

Tighten
^ Screws to 1 N.m (9 lb in).

10. Escutcheon cover.