Cruise Control: Adjustments
NOTE: The release switch and stop lamp switch cannot be adjusted until after the brake booster pushrod is assembled to brake pedal assembly. Refer to Fig. 3 when performing this procedure1. Depress brake pedal and insert release switch stop lamp switch assembly into retainers until fully seated.
2. Slowly release brake pedal beck to its original position. Release switch and stop lamp switch assemblies will move within retainers to their adjusted position.
3. The following brake pedal travel distances can be used to check for properly adjusted release switch and stop lamp switch assemblies:
a. Release switch and stop lamp switch assembly contacts must be open at 1/8 to 1/2 inch brake pedal travel, measured at centerline of brake pedal pad.
b. Nominal actuation of stop lamp switch contacts is about 3/16 inch after cruise switch control contacts close.