Rear Door

REAR DOOR MODULE ASSEMBLY - REPLACEMENT






REMOVAL
1. Remove trim panel, trim brackets, and water deflector.
2. Tape window to door at header.
3. Disconnect lock rods from latch. Discard lock rod clips.
4. Disconnect wire harness bundle and position out of way.
5. Remove upper and forward nuts on module and two nuts from window sash to module.
6. Remove module.

INSTALLATION

NOTICE: Crossarms cannot be repaired. If damage occurs to crossarm assembly, replace module.

1. Install new lock rod clips to latch.
2. Install module to door.
3. Install upper and forward nuts.
4. Connect lock rods and harness bundle.
5. Remove tape from window and install sash to module nuts. Adjust window.
6. Install water deflector and trim panel.