Service Procedure

INSPECTION

To determine if left (driver side) headlamp needs replacing:

1. Look at front of left lens. There are three (3) aiming pads (raised nubs) on the lens.





Look at the lower outboard pad, imprinted above the pad is a number (see figure).

^ If the number is 11, the headlamp does not need replacing. Proceed to Step 8 of Replacement.

^ If the number is 8 or any number other than 11, the headlamp must be replaced. Proceed to Step 1 of Replacement.

REPLACEMENT

1. Open hood.

2. Remove spinner nuts (2) and plastic spacer washer from left (driver side) headlamp assembly.

3. Remove bulb connectors (2) and park/turn sockets (2).

4. Remove headlamp assembly and render unusable (lens must not be reused).

5. Reverse Steps 2 and 3 to install new headlamp assembly.

6. Check operation of headlamp and park/turn signal.

7. Aim headlamps.

8. Install Campaign Identification Label and close hood.